Printmaster platinum 18 default project file path
Make sure the option labled "auto insert notification" is NOT checked. Finally, under setting you should see a series of "options". Double click on this heading for your CD ROM drive which will open its' properties. This will open a heading for your CD ROM drive. From here double click on the "CD ROM" item. Once in the system screen, click on the "device manager" tab. To do this, go to the start button on the task bar, select "control panel", then "system". If anyone is having this problem and is using WIN 95, I would recommend that you disable the auto-notify feature. To make a long story short, I realized that the "auto-run" feature was causing my problem. Of course, I didn't want to do either, I just wanted to get back into the project I was working on.
Printmaster platinum 18 default project file path install#
On the few occasions when this didn't happen, I would get the initial PM screen asking if I wanted to install the program or run it. It seemed that when I closed the CD drawer the computer would start the CD ROM drive and then either lock up the program or cause a general protection fault.
![printmaster platinum 18 default project file path printmaster platinum 18 default project file path](https://i.imgur.com/IZCDhWe.png)
![printmaster platinum 18 default project file path printmaster platinum 18 default project file path](https://venturebeat.com/wp-content/uploads/2018/10/8732f3e6-d000-4a62-83f3-ae0b0923158e.png)
After installing PMP and starting to use the program I found that after I had loaded a graphic and then gotten the message to re-insert the "program CD" I would run into problems. Here are a few additional ideas on PM crashing while using the various graphic CD's. PrintMaster Tips and Techniques PrintMaster Tips and Techniques Back to Index Subject: PMP crashing - "auto notification"